To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *14031 (+5)
  Re: RF Module
 
Hi. Have you tried attaching the data out (middle pin on three pin header) from the encoder board to the data in (also middle pin on three pin header) on the decoder with a common ground to each? This will allow you to test the encoder/decoder (...) (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
 
  Re: LMD18200
 
(...) Correct, it has a minimum voltage for correct operation. You can use a separate battery pack with a higher voltage and simply connect the grounds to your 9.6V battery. This chip is NOT a 293 replacement. You would have to build a small circuit (...) (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
 
  hb
 
Hi all!! Have someone the eagle files *.sch and *.brd for the hb? Thanks markus (27 years ago, 9-Sep-99, to lugnet.robotics.handyboard)
 
  Re: show-me training
 
I know that the RCX is the state of the art LEGO computer, but I happen to have a CyberMaster and I noticed all you have said about the Show-me Training (R) applies perfectly to the CyberMaster and much better than the RCX since no extra inputs need (...) (27 years ago, 9-Sep-99, to lugnet.robotics)
 
  Re: Sound
 
(...) I'm not sure this will help nor if anyone else said anything. I haven't had time to read through everything. So I apologize for redunancy. From the Pitsco/Dacta catalog there is something called a "Sound Element". It's this little round piece (...) (27 years ago, 9-Sep-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR