To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1301 (+5)
  Stepper Motors driving  [DAT]
 
Hi - I am new to this list but the archive indicates some interest in driving stepper motors on the HB so here is my little bit: If we have a typical four coil, unipolar stepper such as those found in disk drives, they will have connections (...) (30 years ago, 21-Jan-97, to lugnet.robotics.handyboard)
 
  RE: dual servo update
 
Two things to note in the servo investigation: (...) This supplies a reserve of current to the servos, and that allows them to seek to their desired position faster. (...) Two servos, when moving, can pull two AMPS of current. Thats 2000mA. Two (...) (30 years ago, 21-Jan-97, to lugnet.robotics.handyboard)
 
  MEMORY FAULT
 
When I turn my HB on I get the message "MEMORY FAULT" what does it mean and how do I fix it? Thanks, Peter Eacmen (30 years ago, 21-Jan-97, to lugnet.robotics.handyboard)
 
  Re: Twitchy servos
 
(...) I'm using a 80C32 board and control two servos by generating a PWM signal with a timer interrupt. It frequently happens that the servos twitch. In my experience the period of 50 ms of the PWM signal was too great. The problem disappeared when (...) (30 years ago, 21-Jan-97, to lugnet.robotics.handyboard)
 
  dual servos
 
Good Day, A consensus seems to be emerging among those who know more about pcode interrupt structure than I. The printf function does indeed disable the interrupts and run that way for quite a long time. Thus, the servo twitching seems to be mostly (...) (30 years ago, 21-Jan-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR