To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1291 (+5)
  mosfet H-bridge
 
Hello, does anyone know how to build a mosfet hbrige and, if so, could they pass that on to me? It is my understanding that the mosfet hbridge does not heat up near as much as the transistor hbridge nor does it have any loss of voltage or current (...) (30 years ago, 20-Jan-97, to lugnet.robotics.handyboard)
 
  RE: mosfet H-bridge  [DAT]
 
Sure, I've built several. The only "trick" to MOSFET bridges is that if you use all N-channel FETs you need a charge pump on the upper FETS. (look out for typos, this was done 'off the cuff' so to speak.) Chuck's Simple MOSFET Tutorial ---...--- (...) (30 years ago, 20-Jan-97, to lugnet.robotics.handyboard)
 
  Re: mosfet H-bridge
 
I would also be interested in plans for such an H-Bridge. I have two 12Vdc motors than take 3.5 Amps at full load (actually gearhead motors so I get lots of torque @50 RPM) but they have surges us to 12 - 14 Amps at start-up and if they get stalled. (...) (30 years ago, 20-Jan-97, to lugnet.robotics.handyboard)
 
  IR Demodulator
 
Hello Everyone, I have had absolutely no luck in getting a IR Demodulator for my HB. I have tried every source given on this sight and even more. Can anyone help me to locate this part? Sharp (IS1U60) Having No Luck! Bill Rose (30 years ago, 21-Jan-97, to lugnet.robotics.handyboard)
 
  dual servo update
 
Hi, For any interested dual servo users the following is what I have been able to find regarding the twitching. Wiring a 1000microf electrolytic across the 6V within inches of each servo seems to work. However, a much more important fix has been (...) (30 years ago, 21-Jan-97, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR