 | | RE: Temperature sensor limits?
|
|
# From: tja@cpu.com # Sent: Thursday, April 15, 1999 04:58 PM # To: lego-robotics@crynwr.com # Subject: Temperature sensor limits? # ---...--- # Does anybody know what the measurement limits are for the temperature # sensor (particularly on the high (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Novice group
|
|
This one sounds like a good idea to me. Steve (...) (28 years ago, 15-Apr-99, to lugnet.admin.general, lugnet.robotics)
|
| |
 | | Re: Novice group
|
|
With the current amount of traffic going by these days, I'd say this is not necessary. Besides, it's refreshing to answer some basic questions once in a while. :-) I suspect the traffic will peak again in September to December, when LEGO introduces (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Temperature sensor limits?
|
|
(...) (Bitter) Experience tells me that at about 80 degrees Celsius*) the Lego plastic starts to get noticeably softer. At 90 to 100 degrees Celsius it will start to deform slowly without pressure. At this temperature most Lego will sustain (...) (28 years ago, 15-Apr-99, to lugnet.robotics)
|
| |
 | | RE: SENSOR_READ doesn't return 0
|
|
(...) OOPS, that SHOULD read 0x0080 since the mode is a BYTE value. Overzealous urge to get content into the website is to blame. For the light sensor, I generally use the percent of scale mode. My website has a page on tricks with the light sensor (...) (28 years ago, 15-Apr-99, to lugnet.robotics.rcx.pbforth)
|