 | | Re: Servo DEinitialization.
|
|
I'd go for the Coke can idea. Sounds like a surer shot. I thought init_expbd_servos(x), where x = integer from 0 to 5, was used to initialize the servos individually. Stupid me. I've been using init_expbd_servos(5), and, since I only had #5 hooked (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: clutch gear
|
|
(...) No, but it's probably the cheapest, unless it's in a Dacta spare parts kit I don't know about. Target had the 3735s on sale for over 50% off. It's also in the 8479 Bar Code Multi set, but that's $160. These are the only two sets that have it (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Dark seeker project
|
|
I have finally built a creation with my Mindstorms kit that uses all of the sensors (some twice) and all of the motor connections! It has two bump switches for a collision detector on the front, one of my RCX IRPD modules to try to detect potential (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Servo DEinitialization.
|
|
(...) as it says in the docs: init_expbd_servos(int action) If action is zero, servo control signals are disabled. If action is non-zero, servo control signals are enabled. Control signals are disabled by default every time the Handy Board is reset. (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Servo DEinitialization.
|
|
Sorry. I'll reread the documentation. I was going by memory. Fred G. Martin Fred G. Martin (...) Ross Tonkens (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|