To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1071 (+5)
  Handyboard testing
 
Have just got to the testing stage this lunch time and have a few problems. 1) When testing the motor ports the LEDs light up in the sequence M0 green - M0 red - M1 red - M1 green - M2 green - M2 red - M3 red - M3 green. This differs from the (...) (30 years ago, 6-Dec-96, to lugnet.robotics.handyboard)
 
  memory fault
 
I was working with IR detectors this morning when this happened.... one detector was connected to the special detector port provided in the handy board. There was a second one connected to the first digital port. They were working fine and i was (...) (30 years ago, 6-Dec-96, to lugnet.robotics.handyboard)
 
  (Handy-B) wrong connection...
 
Hello, I made a terrible mistake. By mistake I connected the pos. side of the powerheader (10 V) to the middle row of the digital ports (Vccc ; 5 V , (if I'm not mistaking)). With this action I probably blew up (a) component(s) on my handyboard. I (...) (30 years ago, 6-Dec-96, to lugnet.robotics.handyboard)
 
  Reflectance sensor hook up??
 
I was looking on the Handy Board web page instructions on howw to wire sensors and motors to the HB. I thought that the two smaller ends went to ground and the longer transmitter side with a 330ohm resistor went to the 5v port and the longer recever (...) (30 years ago, 6-Dec-96, to lugnet.robotics.handyboard)
 
  successful downloading
 
Greetings, Thanks to all who replied. I downloaded dlm.exe and a new copy of pcode and it worked with the -256 option. The old version of dlm which I had did not recognize the -256 option, and I think that was the root of the problem. Onward..... (...) (30 years ago, 6-Dec-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR