Subject:
|
Handyboard testing
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 6 Dec 1996 13:53:00 GMT
|
Original-From:
|
Church, Steve (mailhub) <churchs@racal-survey.co.ukAVOIDSPAM>
|
Viewed:
|
2304 times
|
| |
|
|
Have just got to the testing stage this lunch time and have a few
problems.
1) When testing the motor ports the LEDs light up in the sequence M0
green - M0 red - M1 red - M1 green - M2 green - M2 red - M3 red - M3
green. This differs from the assembly manual which says it should go
green, red, green, red etc.
2) When loading hbtest.c into IC I get warnings that the functions
'start_press', 'knob' and 'stop_button' are not defined. I had to
comment out the 'testanalogs' routine in 'hbtest' to get the other tests
to run.
Any suggestions anyone?
Steve
churchs@racal-survey.co.uk
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
