 | | Increasing current output to motors on HandyBoard
|
|
I am looking to drive a radioshack motor off my HB. Its rated at 9V - 18V. It claims that at maximum efficiency it will draw 1.98 Amps. My HB uses the TI sn754410ne motor controller and is rated only up to 1 amp. If i replace this unit with a L293b (...) (28 years ago, 9-Apr-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Web based LegOs compiler for the underprivileged?
|
|
(...) I am all over that! Might even be done tonight (EST) yet. -SMQ Shawn Menninga smq@dwarfrune.com --=--=--=--=--=--=--...-=--=--=-- "Well I've wrestled with reality for thirty-five years now, doctor, and I'm happy to state I've finally won out (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
|
| |
 | | re: legOS for the helpless
|
|
=>From: David Chen <nospam-dcchen@pacbe...et-nospam> =>... =>Since (I assume) there are many out there who are having a really tough =>time getting a working LegOs development environment working on their =>various systems (Mac, Winblows, etc...), (...) (28 years ago, 9-Apr-99, to lugnet.robotics)
|
| |
 | | (canceled)
|
|
|
| |
 | | Re: Increasing current output to motors on HandyBoard
|
|
(...) Stacking the chips is doable but you will toast them when you get near their current limit. An easier solution is to use the TI chips to drive power transistors that are acting as voltage followers. This lets them take the current. (...) (28 years ago, 9-Apr-99, to lugnet.robotics.handyboard)
|