To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *1061 (+5)
  (no subject)
 
Hi, I get this message attached to some of you guys' mail. Does anyone know what it means? This message contains non-ASCII text, which can only be displayed properly if you are running X11. What follows may be partially unreadable, but the English (...) (30 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
 
  Re: SPI code
 
(...) Just to be clear: the code I have promised is 1200 asynchronous serial output from the HB (from a pin other than its built-in RS-232 out :-), *not* SPI code. Mike is correct in stating the place for info is the 6811 "pink book." See the HB (...) (30 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
 
  baud rates
 
Hi all, I have a question concerning baud rates and the SCI port. I looked in one of the pink books and found the maximum baud rate it shows is 131.072k baud. I need it to be 250k baud. I also noticed that the baud rate is dependant on the crystal (...) (30 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
 
  infrared communication
 
Hello, I'm trying to find information on how to implement infrared communication between my PC and my RugWarrior (a 68HC11 board). I want is to use the serial interface of the board (another port would be fine btw), which is normally connected via a (...) (30 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
 
  Polyswitch Fuse
 
I looked up the part in DigiKey Catalog. Is there a reason for choosing a fuse rated at 2.5A with a trip of 5.0A? (30 years ago, 6-Dec-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR