 | | Re: Idle process
|
|
(...) The idle task actually has the lowest priority in my scheme, but there was some efficiency gained in making the task list loop around. If the idle task is always there, it makes for simplified code in multitasking startup if you rely on that. (...) (28 years ago, 11-Mar-99, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: programming???
|
|
(...) I use the RCX Command Center and NQC to program. RCXCC is a very nice environment for writing, debugging, downloading, and calibrating values. You can directly control the brick from the PC, directly look at all of the sensor values, poll (...) (28 years ago, 11-Mar-99, to lugnet.robotics)
|
| |
 | | Sensor readings on the RCX display
|
|
I know that you old-timers (?-) out there already know this, but I just learned it last week and some others may not know by now. You can read the sensor values directly on the brick's display by pressing the "view" button repeatedly until the (...) (28 years ago, 11-Mar-99, to lugnet.robotics)
|
| |
 | | Where do I get Spirit.ocx?
|
|
Please Help!!! Adamski _______ <adamski2000@adamski...rve.co.uk> (28 years ago, 11-Mar-99, to lugnet.robotics)
|
| |
 | | Re: Get 8 Outputs from RCX: A Pure-Lego Solution
|
|
(...) But then we run out of outputs for the controlling motors. On the other hand, we may layer four stages of the 4-way splitter into a 256- way, then use both directions of the other two outputs to control these four stages... I think this is (...) (28 years ago, 11-Mar-99, to lugnet.robotics)
|