 | | non-pre-fab hulls —Corrine Pearce
|
| | | As a new person on this newsgroup, I apologise if this question has been asked and answered before. Has anyone tried and succeeded to build a pirate ship hull using just ordinary bricks? Is it reasonably possible or does I always have to have a pre (...) (24 years ago, 22-Jun-00, to lugnet.pirates)
|
| | | |
| | | | | Re: non-pre-fab hulls —Thomas P. Rafert
|
| | | | | (...) I know of at least two very large ships:(neither of which are mine) (URL) wonderful ships. I know there are smaller ones but I can't seem place them right now. Tom (24 years ago, 22-Jun-00, to lugnet.pirates)
|
| | | | | |
| | | | | | | Re: non-pre-fab hulls —Corrine Pearce
|
| | | | | | (...) asked (...) Thank you for pointing me in the right direction to give me an idea where to start. (24 years ago, 23-Jun-00, to lugnet.pirates)
|
| | | | | | |
| | | | | Re: non-pre-fab hulls —Matt Brooks
|
| | | | | (...) I have in the past made massive ships by using just bricks (this was before I had any pre-fab hulls). Not only is it possible, it's a TON of fun. It allows you to build intricate lower decks, with a number of details that are more difficult (...) (24 years ago, 22-Jun-00, to lugnet.pirates)
|
| | | | | |
| | | | | Re: non-pre-fab hulls —Matt Brooks
|
| | | | | (...) I have in the past made massive ships by using just bricks (this was before I had any pre-fab hulls). Not only is it possible, it's a TON of fun. It allows you to build intricate lower decks, with a number of details that are more difficult (...) (24 years ago, 22-Jun-00, to lugnet.pirates)
|
| | | | | |
| | | | | | | Re: non-pre-fab hulls —Corrine Pearce
|
| | | | | | (...) asked (...) That sounds so good. I figured that I would need a lot of inverts and I don't have them but I do like the idea of a wider more detailed ship below decks. Thanks (24 years ago, 23-Jun-00, to lugnet.pirates)
|
| | | | | | |
| | | | | Re: non-pre-fab hulls —Sergio Guerra
|
| | | | | (...) Hi, Me and my friend made a brick ship when we were 10 (5 years ago). It is so easy! For the base, all you have to do is start with a 2 stud wide keel, however long you want it. Then, on top of that, add a 4 stud wide layer and make it 2 studs (...) (24 years ago, 23-Jun-00, to lugnet.pirates)
|
| | | | | |
| | | | | Re: non-pre-fab hulls —Tim Coats
|
| | | | (...) I have had good luck with inverse med. slopes, large plates, and long beams. I used these in the longship at my models page: www.cyberis.net/~tco...models.htm Timbo (24 years ago, 14-Jul-00, to lugnet.pirates)
|
| | | | |
