|
|
 | | Re: Hermaphrodite Pin?
|
| (...) No, Lego apparently can't justify the cost of producing the mold for such a part, nor that of a plate with studs on both sides; however, you can have your fill of useful parts like this: (URL) :-) Mark (21 years ago, 14-Oct-04, to lugnet.parts, FTX)
| | | | | Re: Hermaphrodite Pin?
|
| (...) Like others have said, no I don't think there's such a pin. However, I have tried using this part: (URL) When I was a kid, I broke the "clip" part off the 1x1 plate and used the round clip to attach two plates back to back. You'll have a (...) (21 years ago, 14-Oct-04, to lugnet.parts, FTX)
| | | | | Re: Hermaphrodite Pin?
|
| (...) I think it does exist (as a plate, anyway), just not available to the public. I believe a holiday S@H catalog from a couple of years ago had one on the cover. I can't find a scan of it and don't have a copy, but remember noticing it. The cover (...) (21 years ago, 14-Oct-04, to lugnet.parts)
| | | | | Re: Hermaphrodite Pin?
|
| Hello! Such a pin doesn't exist. But maybe this would be of use for you? (URL) (21 years ago, 14-Oct-04, to lugnet.parts)
| | | | | Re: Hermaphrodite Pin?
|
| (...) Nope. Not that I've ever seen. (...) The only pin with a stud on it is the (URL) 1/2 pin>, though the TECHNIC pin tip is only slightly wider than a stud, and can usually be used like one. In fact, many of the basic bricks are being produced (...) (21 years ago, 14-Oct-04, to lugnet.parts, FTX)
|
|
