Subject:
|
Re: Need help identifying part.
|
Newsgroups:
|
lugnet.parts
|
Date:
|
Sun, 20 Aug 2006 01:55:47 GMT
|
Viewed:
|
6284 times
|
| |
|
|
In lugnet.parts, John Cooper wrote:
> In lugnet.parts, John Pannell wrote:
> > I will try to describe this as best as I can.I do not have a digital camera or I
> > would post a link to it.Well,here goes, it is round,overal diameter 8 3/8inches
> > +-,inside diameter is 6 3/4 inches +-,at first glance it looks like a bike
> > wheel.The whole outside circumference is covered with small rounded edge plates
> > that are 3/8 inch tall and 1/4 inch apart,so there are a lot of them. The main
> > shape of this thing is of a steel 'I' beam.Those plates are mounted on the top
> > flange.The 6 3/4 dimension is the diameter of the single row of gear teeth in
> > the middle of the bottom flange, and lots of them too.Thats about as good as I
> > can do.Like I said,if you cut a section thru this thing, the main part will look
> > like a steel 'I' beam.
> > I would appreciate any help.
> > Thank you.
> >
> > John
> >
> > Oh yes, I actually have two of these.And it is made by Lego.They are marked
> > '2002 Lego Group',but nothing else.
>
> Sounds like it might be the wheels from this set?
>
> <http://www.peeron.com/inv/sets/4481-1>
That is it! And I actually looked at all the Technic sets in Star Wars.I
I guess I missed one. But thank you very much.
John
|
|
Message is in Reply To:
4 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
