Subject:
|
Re: Need help identifying part.
|
Newsgroups:
|
lugnet.parts
|
Date:
|
Sat, 19 Aug 2006 01:50:04 GMT
|
Viewed:
|
6391 times
|
| |
|
|
In lugnet.parts, John Pannell wrote:
> I will try to describe this as best as I can.I do not have a digital camera or I
> would post a link to it.Well,here goes, it is round,overal diameter 8 3/8inches
> +-,inside diameter is 6 3/4 inches +-,at first glance it looks like a bike
> wheel.The whole outside circumference is covered with small rounded edge plates
> that are 3/8 inch tall and 1/4 inch apart,so there are a lot of them. The main
> shape of this thing is of a steel 'I' beam.Those plates are mounted on the top
> flange.The 6 3/4 dimension is the diameter of the single row of gear teeth in
> the middle of the bottom flange, and lots of them too.Thats about as good as I
> can do.Like I said,if you cut a section thru this thing, the main part will look
> like a steel 'I' beam.
> I would appreciate any help.
> Thank you.
>
> John
>
> Oh yes, I actually have two of these.And it is made by Lego.They are marked
> '2002 Lego Group',but nothing else.
Sounds like it might be the wheels from this set?
<http://www.peeron.com/inv/sets/4481-1>
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Need help identifying part.
|
| I will try to describe this as best as I can.I do not have a digital camera or I would post a link to it.Well,here goes, it is round,overal diameter 8 3/8inches +-,inside diameter is 6 3/4 inches +-,at first glance it looks like a bike wheel.The (...) (18 years ago, 19-Aug-06, to lugnet.parts)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
