| |
In lugnet.org.us.michlug, John Warren writes:
> In lugnet.trains, James Trobaugh writes:
> > In lugnet.trains, Larry Pieniazek writes:
> > > In lugnet.trains, James Trobaugh writes:
> > > > Congrats on the first place finish.
> > > >
> > > > I noticed that this show you had the plexiglass up, how did you attach that
> > > > to the tables? I know that you are not using custom tables, but just the
> > > > standard issued banquet tables, so I'm curious how you got the glass to >attach.
> > >
> > > Drat, I KNEW there was something I forgot to take better pictures of.
> > >
> > > These are amazingly clever, worked out great, and are highly recommended.
> > > Bear with this verbal description. Credit goes to Steve R. (this was his
> > > maiden show and he ROCKED the place with his stunning engine facility as
> > > I've been mentioning... The pics I am uploading to Brickshelf as we speak
> > > give more detail on his roundhouse and turntable construction) for the
> > > building of these.
> > >
> > > OK, here goes.
> > >
> > > 1. Take a binder clip, a big one, that has a 1 inch open when fully opened.
> > > 2. Bend off one of the clip levers and unroll the central rolled up part so
> > > it's flat metal and sticks out farther
> > > 3. Cut off the outer parts at 45 degree angles. This leaves the central part
> > > sticking the farthest out...
> > > 4. remove any burrs
> > > 5. Screw this clip (through the back part, so both open flanges face out) to
> > > a 2x2 that is straight and not very knotty. The bottom clip handle should be
> > > a tiny bit below the bottom of the 2x2.
> > > 6. Take a piece of plexi, 9ish inches high, and another 2x2 and make a
> > > sandwich. Screw another clip to the other end
> > >
> > > To install, use the bottom lever and the point of the top to attach to the
> > > end of the banquette table. When you have several lined up, put plastic
> > > glass trim on the tops, overlapping the joints to make a continuous run.
> > > Staple the tablecovers GATS gives you (ripped in half the long way with a
> > > razor or scissors, this goes really fast if you have two people holding the
> > > cloth) to the outer 2x2.
> > >
> > > Voila.
> >
> > I too wish you took some pictures of that. I'll have to re-read your
> > description again in the morning when I'm a bit more awake, I can't quite
> > picture it right now.
> >
> > I really want to figure it out though, I think the plex attachment is the
> > only thing holding us back from using the show tables when we want to add on
> > to our layout.
> >
> > jt
> I agree, James. We definitely need to figure this out so we can incorporate
> it into our club design. I'm awake and still having a hard time visualizing
> this design. Sounds like an intriging design.
> Later,
> John Warren
|
|
Message is in Reply To:
15 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
