 | | Re: 3T Board Change Suggestion
|
|
(...) Either way, tiles at the bottom of the cell would allow the robot to "push" the cube back in the hole so it isn't cocked. (...) My robot also supposedly has .5 stud accuracy..but :) (...) Dropping cubes on their sides does not overcome this (...) (20 years ago, 8-Jan-06, to lugnet.org.us.laflrc)
|
| |
| | Re: 3T Board Change Suggestion
|
|
(...) Well, there was one robot that didn't have this problem too much. The one picture of a cube mysteriously perched on edge next to a board is not doctored - *somehow* my robot just clipped the cube as it left the board, rolling it out of the (...) (20 years ago, 8-Jan-06, to lugnet.org.us.laflrc)
|
| |
| | 3T Board Change Suggestion
|
|
In the posts regarding the get together for 3T, it was mentioned that all the robots had a few issues getting cubes to sit flat in the holes. I have spent a lot of effort to tweak my drop locating method so that it hits the holes perfectly. What I (...) (20 years ago, 7-Jan-06, to lugnet.org.us.laflrc)
|
| |
| | Re: 3T
|
|
(...) My robot also basically rests on a 32x32 plate...I have an extension off the back more for some stability than anything else. (...) Good news - I also have a low riding front end and can help Steve outflank the Vikings at the next get (...) (20 years ago, 7-Jan-06, to lugnet.org.us.laflrc)
|
| |
| | Meeting schedule Jan Feb 2006
|
|
looks like Jan 9 will be snowy so postponing meeting to Jan 14 2006 discuss approaching morris museum for display also any one wishing to trade parts contact people before hand so that trade can be made for needed parts big party coming up in feb (...) (20 years ago, 7-Jan-06, to lugnet.org.us.gardenslug)
|
