 | | Re: Sign is finished! —Kevin Wilson
|
| | | Robin Sather wrote in message <3b47b394.25162868@l...et.com>... (...) Great Robin! Look forward to seeing it. (...) Probably OK, we're not going to be putting much if any stress on this. (...) Cutting this stuff, even the 5/64" thickness, with an (...) (23 years ago, 8-Jul-01, to lugnet.org.ca.vlc)
|
| | | |
| | | | | Re: Sign is finished! —Robin Sather
|
| | | | (...) I tend to agree, but then again, take a look at this pic: (URL) Cutting this stuff, even the 5/64" thickness, with an Xacto knife would be a (...) Andrew and Claus are checking the plastic/sign shop route, and I'll know more tomorrow about (...) (23 years ago, 8-Jul-01, to lugnet.org.ca.vlc)
|
| | | | |
| | | | | | Re: Sign is finished! —Dean Husby
|
| | | | (...) I just want to be sure it won't crack on drilling and that it can't be broken easily while people pull on it. I'd hate it to break and hurt someone. (...) I'd prefer the higher tables as well. The "Real" Train guys tables are MUCH higher then (...) (23 years ago, 9-Jul-01, to lugnet.org.ca.vlc)
|
| | | | |
| | | | | | Re: Sign is finished! —Kevin Wilson
|
| | | | Dean Husby wrote in message <3B4902F6.F5ECC105@a....bc.ca>... (...) broken (...) Good point, Dean. The drilling should be OK (just have to lubricate the drill and go slowly so you don't melt the plastic) but someone could certainly pull hard enough (...) (23 years ago, 9-Jul-01, to lugnet.org.ca.vlc)
|
| | | | |
| | | | | | Re: Sign is finished! —Robin Sather
|
| | | | (...) I think that if we were to put some sort of vertical strengthener between the ends of the sheets, it would be much stronger, stiffer, less prone to bending or breaking, and more visible as well. I know that there is something that is designed (...) (23 years ago, 9-Jul-01, to lugnet.org.ca.vlc)
|
| | | | |
