 | | Re: C$ board design
|
| Using a non-standard board makes it a lot easier, since the primary challenge (as I've seen it) has been building a tower that rolls back and forth but is set back from the board enough that the legs don't interfere with it. I think it would be (...) (21 years ago, 10-Oct-03, to lugnet.org.ca.rtltoronto)
| | | | | Re: C$ board design
|
| (...) Well, personally, I'm not sure if it's more "classy" to drive a few screws through the legs of a Connect-4 board, a piece of wood, and a LEGO base-plate. :) But I agree it does change the rules of the game a little bit. However, using the (...) (21 years ago, 10-Oct-03, to lugnet.org.ca.rtltoronto)
| | | | | Re: C$ board design
|
| Here's the board mounting I came up with. (URL) made with parts from a single kit. But if you only have a single RIS, you'll only be able to make one board mount, and that won't leave any 1x16 beams for your robot... The top beam will flip down and (...) (21 years ago, 11-Oct-03, to lugnet.org.ca.rtltoronto)
| |
