| |
In lugnet.org.ca.rtltoronto, Derek Raycraft wrote:
> David, you've cut track before. What do you use to cut the metal cap on
> the rails. I'd like to cut it cleanly without crimping it or bending
> it. I've taken it off the plastic part of the track because I don't
> want to damage that part of the track.
>
> I've thought of using snips but I don't think I'll get a clean end.
> I've tried just doing it with an knife but it's just not cutting through
> and I'm afraid of crushing it. Maybe a dremel would work, but I've
> always found them hard to control.
>
> Does anyone have a dremel and is not currently in Nova Scotia?
I do. Or it might be at Mario's.
Calum
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Cutting Rail
|
| David, you've cut track before. What do you use to cut the metal cap on the rails. I'd like to cut it cleanly without crimping it or bending it. I've taken it off the plastic part of the track because I don't want to damage that part of the track. (...) (21 years ago, 10-Jul-03, to lugnet.org.ca.rtltoronto)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
