To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.org.ca.rtltorontoOpen lugnet.org.ca.rtltoronto in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Organizations / Canada / rtlToronto / 7423
7422  |  7424
Subject: 
Re: I know Kung Fu!
Newsgroups: 
lugnet.org.ca.rtltoronto
Date: 
Thu, 22 May 2003 15:38:59 GMT
Viewed: 
955 times
  
In lugnet.org.ca.rtltoronto, Gerard Steenbeek writes:
err, I mean: "I know NQC"...

NQC for RCX2 firmware that is.
I opened my first RIS set on sunday night, built the rover and played with
some simple touch sensor stuff. I did all the challenges for the rover on
monday, at this point I basically knew how the RIS software worked. At the
end of monday I assembled the Acrobot, but it was stupid and the bumper
wasn`t strong enough and all the chalanges were similar or stupid or I
already did that on the rover. So I took it apart and started building the
Candy Sorter since it had the most mechanics and uses colour detection.
Finished building it on Tuesday afternoon and played with it a little bit,
then Decided I needed to learn NQC. Found a good guide on NQC read
everything in it that applied to RCX2. Found BrickCC online downloaded it,
and started messing with the code to test some simple functions. Then I
wanted to make something work, and since the candy sorter was together I
wrote software for it. It worked faster too.This morning I wanted to try out
events and multitasking, So I added an emergency stop event and then later
removed that to use the sensor for multitasking. It was sorting
candy(marbles) and when I presses the touch sensor on port 2, a motor on
output B would spin, and stop when I let go.

Now that I know how it works, I really like it, MUCH easier to work with
than RIS software.


Nice Work.  I hope you enjoy the RIS 2.0.  (I still don't have one yet.
I DO have a couple 1.0's and a 1.5).

Seen Matrix Reloaded yet???

I seen it last Saturday.  I thought it was very cool.  Interesting plot
development, but was a bit disapointed in some of the tangents the movie
went in.

Ben.



Message is in Reply To:
  I know Kung Fu!
 
err, I mean: "I know NQC"... NQC for RCX2 firmware that is. I opened my first RIS set on sunday night, built the rover and played with some simple touch sensor stuff. I did all the challenges for the rover on monday, at this point I basically knew (...) (22 years ago, 21-May-03, to lugnet.org.ca.rtltoronto)

5 Messages in This Thread:


Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR