 | | Re: My First Stacking Attempt —Rob Stehlik
|
| | | I just had some more thoughts on your mechanism... Using curved guides up front should elimenate most of your block alignment problems. Use a couple of those big sloped znap pieces like Chris did. This way, you would only have to drive the grabber (...) (24 years ago, 2-Feb-01, to lugnet.org.ca.rtltoronto)
|
| | | |
| | | | | Re: My First Stacking Attempt —Calum Tsang
|
| | | | (...) That was the plan, but it's a little more insidious than that. :( It's not just the floor plane, it's the alignment in the other plane-ie, it's if a block hops into the wheels (ie, being bumped by another block behind it, or being bumped by an (...) (24 years ago, 7-Feb-01, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: My First Stacking Attempt —Rob Stehlik
|
| | | | (...) Ummm.... I probably wouldn't do it, but I haven't seen how well the spinning tires work. I am also partial to minimizing motors. But your plan is a lot simpler. (...) Sounds like you are well on the way! I will either bring a demo model of my (...) (24 years ago, 8-Feb-01, to lugnet.org.ca.rtltoronto)
|
| | | | |
| | | | | | Re: My First Stacking Attempt —David Koudys
|
| | | | (...) My lpatop will be there. I come straight from work so laptop always comes in tow. Thinking about taking a few vacation days next week so I can finalize my 'bot. Boss is pretty excited about the whole thing, might even show at the event Dave (24 years ago, 8-Feb-01, to lugnet.org.ca.rtltoronto)
|
| | | | |
