| |
Steven,
My bad. 880A.DAT is an LSynth part that I failed to add to the setup list.
You can make one of your own by copying 880.DAT to 880A.DAT. Edit 880A.DAT
and remove the electric cord stub.
I'll add it tto the distribution.
Thanks,
Kevin
In lugnet.cad, Steven Combs writes:
> Kevin,
>
> Quick technical question. When I try to use the part 2982C02.DAT ~Electric Light Sensor (Complete Assembly Shortcut
> without wire) I receive a "File 880A.DAT not found! Continue loading?" error. When I respond yes, it loads the sensor
> but without the top. Question: is this an LSYNTH part? If so, am I to assume that I am missing the 880A.DAT part? And
> finally if so and it is an LSYNTH part, where do I obtain this .DAT file?
>
> Thanks!
> --
> Steven
|
|
Message has 1 Reply:
 | | Re: LPub 2.1.0.6 Available
|
| (...) OK...I'm new to editing .DAT files (although this is an area I would like to improve). That was just too cool. I used LDraw Design Pad, removed the lines under the wire stub area, previewed the image (using the LDView button) and the wire was (...) (22 years ago, 29-Jan-03, to lugnet.cad, lugnet.inst, lugnet.cad.dev)
|
Message is in Reply To:
| | Re: LPub 2.1.0.6 Available
|
| Kevin, Quick technical question. When I try to use the part 2982C02.DAT ~Electric Light Sensor (Complete Assembly Shortcut without wire) I receive a "File 880A.DAT not found! Continue loading?" error. When I respond yes, it loads the sensor but (...) (22 years ago, 28-Jan-03, to lugnet.cad, lugnet.inst, lugnet.cad.dev)
|
15 Messages in This Thread:
 
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
