 | | Re: Defining the "term" BI
|
|
(...) I know. I was just teasing you about the book thing, because we *are* both in the same boat. Notice I immediatly followed with the list. Kevin (...) (21 years ago, 18-Sep-03, to lugnet.inst, lugnet.cad, FTX)
|
| |
| | Re: Defining the "term" BI
|
|
'snip' (...) I'm in the same boat as you on this issue of "book topics". I'm still wrtiting tutorials on subjects that I already helped cover in a book with Tim but that does the general public no good, unless they buy the book. However as the LDraw (...) (21 years ago, 17-Sep-03, to lugnet.inst, lugnet.cad, FTX)
|
| |
| | Re: Defining the "term" BI
|
|
Overview Model - the entire design being described by the building instructions. Building steps - the sequence of steps where parts are added to assemble the entire model. Sub-model - portions of the model that are described as their own set of (...) (21 years ago, 17-Sep-03, to lugnet.inst, lugnet.cad)
|
| |
| | Re: Defining the "term" BI
|
|
(...) I think I've already written a book that does this, which you haven't read :^) If you had you wouldn't have posted the original post that got all this going! Sure I'll add definitions for all the terms I use. (...) (21 years ago, 17-Sep-03, to lugnet.inst, lugnet.cad, FTX)
|
| |
| | Re: Defining the "term" BI
|
|
(...) I don't have any comments about it at the moment, but being that you have authored the 1st BI term page. =) I think we should used your page as our foundation. Perhaps you can "volunteer" again =) and write definitions for each of the terms. I (...) (21 years ago, 16-Sep-03, to lugnet.inst, lugnet.cad, FTX)
|
