To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.generalOpen lugnet.general in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 General / 46814
46813  |  46815
Subject: 
Re: Different mold on 1x6, 1x8
Newsgroups: 
lugnet.lego.direct, lugnet.general
Date: 
Sat, 3 Apr 2004 05:48:03 GMT
Viewed: 
257 times
  
In lugnet.lego.direct, Ross Crawford wrote:
> Has anyone else noticed this? It seems newer 1x6 & 1x8 bricks have a different
> mold. See this comparison:
> 
> http://www.brickshelf.com/gallery/RoscoHead/bricklink/bottom.jpg
> 
> The older brick on the left has holes in the bottom studs, but more importantly,
> the flanges on studs 2 & 4 don't go all the way to the bottom of the brick. The
> newer brick, on the right, has no holes and the flanges go right to the bottom.
> 
> This may not seem like a huge difference, but what it means is I can no longer
> attach these bricks to one of these:
> 
> http://guide.lugnet.com/partsref/search.cgi?q=4274



> 
> by those 2 studs, because the flanges don't allow the rim of the pin's stud to
> go up inside the brick.
> 
> THIS IS BAD!!!!! And though I know most probably don't care, I use this
> technique for connection often!
> 
> So far, I've only seen it in newer 1x6 & 1x8s, but who knows how far it will
> infiltrate in future?
> 
> Does LEGO Direct have any comments, or able to shed a light on why this
> incompatibility has been introduced?
> 
> ROSCO

I did a little check on my 1xn bricks and saw this "problem" on all types and
colours, from 1x2 to 1x8.
In my opinion, there are two or more moulds, each with a little difference, and
they change them every now and then. (For cleaning and maintenance, I think)
There is no indication that there is a "new" or "old" type. The past few years,
I got both types.

For me, it is no problem so far, and I had hardly noticed before you mentioned
it.

Leo.



Message is in Reply To:
  Different mold on 1x6, 1x8
 
Has anyone else noticed this? It seems newer 1x6 & 1x8 bricks have a different mold. See this comparison: (URL) older brick on the left has holes in the bottom studs, but more importantly, the flanges on studs 2 & 4 don't go all the way to the (...) (22 years ago, 3-Apr-04, to lugnet.lego.direct, lugnet.general)  

6 Messages in This Thread:





Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR