 | | Is there any way to get pre-applied graphics off of pieces without damaging them?
|
|
I have lots of clear aquanaut and space pieces that would make wonderful town pieces, if only they didn't have those silly pseudo-science-fiction graphics all over them. I know that I can sand them off, since I've used this on non-clear pieces, but (...) (25 years ago, 4-Mar-00, to lugnet.general)
|
| |
| | Re: Is there any way to get pre-applied graphics off of pieces without damaging them?
|
|
(...) Yep. Brasso is the popular one among AFOLs. Personally I haven't tried yet. Lack of time and pieces that need print- removal (that's a good thing, I guess :) Search keyword 'brasso' for previous posts about best ways to use it... Good Luck! (...) (25 years ago, 4-Mar-00, to lugnet.general)
|
| |
| | Re: Is there any way to get pre-applied graphics off of pieces without damaging them?
|
|
(...) Well, I've used said Brasso on UFO panels, and it works rather well. It leaves the pieces slightly less shiny, with a windshield-like moire pattern when held in the light (from directional strokes with the micro-abrasive), but it works very (...) (25 years ago, 4-Mar-00, to lugnet.general)
|
| |
| | Brasso does the trick!
|
|
Brad Hamilton <bhamilto1@home.com> wrote in message news:FqvqAz.LJo@lugnet.com... (...) (25 years ago, 4-Mar-00, to lugnet.general)
|
| |
| | Brasso does the trick pt. II
|
|
It works best if you use cotton balls in conjuction with it. It will leave a slight pattern but it's better than having all that silly-looking paint all over the place! Dave Brad Hamilton <bhamilto1@home.com> wrote in message (...) (25 years ago, 4-Mar-00, to lugnet.general)
|
