 | | LEGO Sculpture: A Birthday Cake
|
|
Thematically I suppose I could have waited a couple of weeks and announced this small sculpture on my own birthday, but I'm sure I'll have something else to announce by then, so here goes: (URL) welcome, eric (22 years ago, 6-Mar-03, to lugnet.build.sculpture, lugnet.general, lugnet.announce.moc, lugnet.build) !
|
| |
| | Re: Washing Legos to get rid of smoke smell
|
|
(...) I have used a liquid disinfectant soap to great success. What I do is dump the smokey parts into a soapy bath and leave them for at least a day, if not several. Then I dump them out (the water often runs black), rinse them, and then run them (...) (22 years ago, 6-Mar-03, to lugnet.general)
|
| |
| | Re: Which weighs more?
|
|
I would bet that this decrease in mass/stud as the brick lengthens has to do with the fact that for the smaller bricks the end 'walls' account for more volume on a percentage basis. eric (...) (22 years ago, 6-Mar-03, to lugnet.general)
|
| |
| | Re: Which weighs more?
|
|
(...) Look a little bit harder. Note that the bottom studs, in a normal brick extending all the way up, are interupted by the pegholes in a technic brick. I estimate that the surface to subtract for the two holes in the brick wall and the surface to (...) (22 years ago, 6-Mar-03, to lugnet.general)
|
| |
| | Re: Washing Legos to get rid of smoke smell
|
|
Use Lysol Kitchen Cleaner - white bottle with purple trim. I use it full strength on ABS Lego that is really bad, or cut it all the way down to about 1/8 strength for the old Acetate Lego or really weathered stuff. It will even take the smoke smell (...) (22 years ago, 6-Mar-03, to lugnet.general)
|
