| |
Richard Parsons <rparsons@hinet.net.au> wrote in message
news:FxrLLw.3y1@lugnet.com...
> Mmmm.
>
> The pirate ship's wheel (dunno if the fabuland one is the same part) fits
> the technic 2x1 block (or any technic connector pin hole), but the wheel
> doesn't have a standard connector pin. Its a very tight fit. I have
> wondered whether the wheel was made of a different abs.
>
> In any event, best plan? Brute force :-)
>
> Richard
> Still baldly going...
>
> Check out Port Block at http://www.hinet.net.au/~rparsons/port/
> "sheree rosenkrantz" <srosez@hotmail.com> wrote in message
> news:FxrH7u.4LI@lugnet.com...
Thanks Richard!
Both the red Fabuland and the brown Pirate?/Divers? ones that I have are
part #4790.
Brute force? Gee . . . I think I'll wait to try that when I get the right
color brick. Once it is connected is the wheel able to turn/spin or is it
just too tight?
sheree
|
|
Message has 1 Reply:
 | | Re: ship's wheel
|
| (...) You can spin it easily, but it's kinda hard to remove the wheel(you can do it). I think it's so hard to put in or out because the technic pin doesn't have the little notch in it, so it won't bend inward and be easier to put in the hole, rather (...) (24 years ago, 16-Jul-00, to lugnet.pirates, lugnet.fabuland)
|
Message is in Reply To:
| | Re: ship's wheel
|
| Mmmm. The pirate ship's wheel (dunno if the fabuland one is the same part) fits the technic 2x1 block (or any technic connector pin hole), but the wheel doesn't have a standard connector pin. Its a very tight fit. I have wondered whether the wheel (...) (24 years ago, 16-Jul-00, to lugnet.pirates, lugnet.fabuland)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
