| |
Mmmm.
The pirate ship's wheel (dunno if the fabuland one is the same part) fits
the technic 2x1 block (or any technic connector pin hole), but the wheel
doesn't have a standard connector pin. Its a very tight fit. I have
wondered whether the wheel was made of a different abs.
In any event, best plan? Brute force :-)
Richard
Still baldly going...
Check out Port Block at http://www.hinet.net.au/~rparsons/port/
"sheree rosenkrantz" <srosez@hotmail.com> wrote in message
news:FxrH7u.4LI@lugnet.com...
> What piece does the pin of the ship's wheel fit into? I thought it would • be
> 3700 the 1x2 brick with a hole, but it doesn't seem to fit.
>
> I've looked up instructions like
> http://www.brickshelf.com/scans/6000/6286/6286-21.htmle
> http://www.brickshelf.com/scans/3000/3673/3673-02.html
> but I can't see what this wheel pin is fitting. Sure looks like 3700.
>
> Help please.
> sheree
>
>
|
|
Message has 1 Reply:
 | | Re: ship's wheel
|
| Richard Parsons <rparsons@hinet.net.au> wrote in message news:FxrLLw.3y1@lugnet.com... (...) Thanks Richard! Both the red Fabuland and the brown Pirate?/Divers? ones that I have are part #4790. Brute force? Gee . . . I think I'll wait to try that (...) (24 years ago, 16-Jul-00, to lugnet.pirates, lugnet.fabuland)
|
Message is in Reply To:
| | ship's wheel
|
| What piece does the pin of the ship's wheel fit into? I thought it would be 3700 the 1x2 brick with a hole, but it doesn't seem to fit. I've looked up instructions like (URL) I can't see what this wheel pin is fitting. Sure looks like 3700. Help (...) (24 years ago, 15-Jul-00, to lugnet.pirates, lugnet.fabuland)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
