| |
Personally, I think the naming should be like this:
For parts with axle holes, use the Liftarm designation
e.g. Technic Liftarm 1 x 11.5 Double Bent for part 32009 and Technic
Liftarm 1 x 3 Thin with Click Rotation Hinge Half Socket for part 41679 and
so on.
For a the thick straight beams with no axleholes like 32278, call them e.g.
Technic Beam Rounded 1 x 15 Straight (Rounded to prevent confusion with
the Techinc Brick xxx with holes)
A part like 32526 can be renamed to Technic Beam Rounded 3 x 5 L Shape
A part like 32017 can be renamed to Technic Halfbeam 1 x 5
|
|
Message has 1 Reply:
 | | Re: Naming Technic Liftarms
|
| (...) I'm not sure that rounded is needed. Brick vs. Beam is very clear. Besides for bricks the count is the number of studs (always even except for 1). For Beams it is the number of holes (typically an odd number, except in the case of 1x2.) Kevin (...) (21 years ago, 28-Mar-04, to lugnet.cad.dat.parts, lugnet.db.brictionary)
|
Message is in Reply To:
| | Naming Technic Liftarms
|
| Not sure if this has been brought up before, but the naming of the technic liftarms leaves something to be desired. It seems mostly the thin ones have just the dimensions, thick ones have "straight" appended. Except for the 4L liftarms. Bricklink (...) (21 years ago, 27-Mar-04, to lugnet.cad.dat.parts, lugnet.db.brictionary)
|
7 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
