| |
Sorry for the delay in response. My internet access was down.
My cathedral is modular. I used sub-parts a lot (there are about 20
sub-parts). For instance, each side of the nave is a separate part, and the
floor is yet another one.
Each of those branches are a separate sub-part too (about 10 pieces
including the branch, the leaves, and the stand). I just place the branch
sub-part where I want in the correct sub-part for the building.
I can always see inside each section of the building because I have
sub-parts that define one wall.
I'd be happy to forward you the complete .dat files if you have insterest in
seeing exactly how its done.
Nicholas Fezie <NSFosaur@aol.com> wrote in message
news:G5yCxs.Dyy@lugnet.com...
> Great job!
> By the way, how do you put those little details like the holly branches • into
> your huge creations in LDraw or MLCad? Do you usually rip off an entire
> side of the cathedral, place the branches and then patch it up or do you • do
> it some other way that works much better? Thanks for the insights.
>
> -Nick
|
|
Message is in Reply To:
3 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
