To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.rayOpen lugnet.cad.ray in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Ray-Tracing / 872
    conversion to POVRAY —Tim David
   Hi This weekend I have been reading the instructions for L3P, both the ones on the site and the ones that come zipped with the program. I can't work it out Could someone give me a brief, clear guide as to how to use it? Thanks, Tim (23 years ago, 11-Jun-01, to lugnet.cad.ray)
   
        Re: conversion to POVRAY —Jake McKee
   (...) I would suggest skipping the learning curve of L3P and download the L3PAddOn program. It is a very nice windows interface that writes out the L3P commands. You can download it at www.Ldraw.org. Jake --- Jake McKee AFOL LUGNET Member #211 (23 years ago, 11-Jun-01, to lugnet.cad.ray)
   
        Re: conversion to POVRAY —Dave Schuler
     (...) Alternatively, I recommend that, if you're going to start with L3P, as I did, your best bet is simply to render the model straight off the page: l3p model.dat and then play around with the POV file within POV-Ray. I'm not especially conversant (...) (23 years ago, 11-Jun-01, to lugnet.cad.ray)
   
        Re: conversion to POVRAY —Larry Pieniazek
     (...) Not a bad choice. Also consider L3Lab... what I like about it is that you can rotate the model to check for stuff you messed up. Yes, you can do that in MLCad as well but it's good as a double check. (23 years ago, 11-Jun-01, to lugnet.cad.ray)
   
        Re: conversion to POVRAY —Tim David
   Hi, thanks for replying (and everyone else) i've downloaded L3PAddOn and got nit running and i can see how changing the setting changes the command line produced. However when i run it all i get is a POVRAY file that consists of a header and lots of (...) (23 years ago, 13-Jun-01, to lugnet.cad.ray)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR