Subject:
|
Re: Can LDAO do this? (was: anyone interested in rendering for me?)
|
Newsgroups:
|
lugnet.cad.ray, lugnet.cad.dev
|
Date:
|
Thu, 13 Jul 2000 16:34:30 GMT
|
Viewed:
|
1377 times
|
| |
|
|
"Sproaticus" <jsproat@io.com> writes:
> The main file for, say, SKETCH.DAT, shows up as a union block named
> sketch_dot_dat. I suppose that a post-l3p tool could just read in
> the POV output file and parse this union and insert the
> clock-checking logic.
Yes, this should be perfectly appropriate. Perl would be a good tool to
do this. Of course, it makes more sense to do this conversion in L3P to
start with... If we can persuade Lars to do it!
On the other hand, I don't like using POV-Ray to generate instruction
images -- I think that too much information is lost when discarding the
information about the edge-lines. So I prefer LDLITE to render
instrucions.
> Actually, Bob's my dad. :-,
Well, that should make it all much easier! :-)
Fredrik
|
|
Message is in Reply To:
15 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
