Ray-Tracing : 421


CAD / Ray-Tracing / 421	420 \| 422

Subject:	Re: Can LDAO do this? (was: anyone interested in rendering for me?)
Newsgroups:	lugnet.cad.ray, lugnet.cad.dev
Date:	Wed, 12 Jul 2000 17:14:05 GMT
Reply-To:	[jsproat@io]spamless[.com]
Viewed:	1327 times

Steve Bliss wrote: > Just an additional loop to spit out a DAT file for each step, then use L3P > to translate it, and POV-Ray to render it. Sweet! Since POV renderings take a while, and that you'd need a POV for each step anyway, I'm wondering if all the L3P output could be saved, e.g. STEP0001.POV, STEP0002.POV, etc. Cheers, - jsproat -- Jeremy H. Sproat <jsproat@io.com> ~~~ http://www.io.com/~jsproat/ Uh, two. Including this one.

Message has 1 Reply:

		Re: Can LDAO do this? (was: anyone interested in rendering for me?)
(...) It is much more sane to use POV-Ray's animation system to do this automatically. That way, you could issue one POV-Ray command and render all the instruction steps in one run, using only one POV-file. I have suggested this to Lars C Hassing, (...) (24 years ago, 12-Jul-00, to lugnet.cad.ray, lugnet.cad.dev)

Message is in Reply To:

		Re: Can LDAO do this? (was: anyone interested in rendering for me?)
(...) Actually, it shouldn't take much change to LDAO. Just an additional loop to spit out a DAT file for each step, then use L3P to translate it, and POV-Ray to render it. Steve (24 years ago, 12-Jul-00, to lugnet.cad.ray, lugnet.cad.dev)

15 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search