Subject:
|
Re: Technics beams and plates?
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Wed, 16 May 2001 02:17:33 GMT
|
Viewed:
|
2131 times
|
| |
|
|
Wha-hoo! That did it.
Thanks alot
Tom Heverly
On Mon, 14 May 2001 23:20:28 GMT, "blessing" <blessing@icefog.net>
wrote:
> Well if your useing MLcad, go to 'file' and select 'scan parts'.
> This will ask you if you want to add any new parts it finds to the
> directory.
>
> When I installed MLcad I had to do this twice before I had all the parts
> that were soposed to be there!
>
> Gary
>
> Tom Heverly <theverly@nospam.hotmail.com> wrote in message
> news:3b001bc8.6666037@news.lugnet.com...
> > I'm trying to build my first L-draw / MLcad model, and my first step
> > was to use a 1x10 technic beam, and since my parts list only has 1x2
> > and 1x14, my virtual creation stopped before it started. I'll bet
> > there is a simple way to convert the 1x14 into all the 1xN beams
> > avail. But I can't seem to figure it out.
> >
> > Same goes for technic plates, only the 2x4 is avail.
> >
> > Do I need to figure out how to modify my existing parts, or is my
> > library incomplete. I downloaded the latest parts list:
> >
> > Current Parts Update LCAD 2000-02 - September 30, 2000
> >
> > I even looked at the UNofficial parts, but there were none to help me.
> >
> >
> > what do I need to do?
> >
> > Thanks
> >
> > Tom Heverly
>
>
|
|
Message is in Reply To:
 | | Re: Technics beams and plates?
|
| Well if your useing MLcad, go to 'file' and select 'scan parts'. This will ask you if you want to add any new parts it finds to the directory. When I installed MLcad I had to do this twice before I had all the parts that were soposed to be there! (...) (24 years ago, 14-May-01, to lugnet.cad.mlcad)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
