Subject:
|
Re: Technics beams and plates?
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Mon, 14 May 2001 23:20:28 GMT
|
Viewed:
|
2174 times
|
| |
|
|
Well if your useing MLcad, go to 'file' and select 'scan parts'.
This will ask you if you want to add any new parts it finds to the
directory.
When I installed MLcad I had to do this twice before I had all the parts
that were soposed to be there!
Gary
Tom Heverly <theverly@nospam.hotmail.com> wrote in message
news:3b001bc8.6666037@news.lugnet.com...
> I'm trying to build my first L-draw / MLcad model, and my first step
> was to use a 1x10 technic beam, and since my parts list only has 1x2
> and 1x14, my virtual creation stopped before it started. I'll bet
> there is a simple way to convert the 1x14 into all the 1xN beams
> avail. But I can't seem to figure it out.
>
> Same goes for technic plates, only the 2x4 is avail.
>
> Do I need to figure out how to modify my existing parts, or is my
> library incomplete. I downloaded the latest parts list:
>
> Current Parts Update LCAD 2000-02 - September 30, 2000
>
> I even looked at the UNofficial parts, but there were none to help me.
>
>
> what do I need to do?
>
> Thanks
>
> Tom Heverly
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Technics beams and plates?
|
| I'm trying to build my first L-draw / MLcad model, and my first step was to use a 1x10 technic beam, and since my parts list only has 1x2 and 1x14, my virtual creation stopped before it started. I'll bet there is a simple way to convert the 1x14 (...) (24 years ago, 14-May-01, to lugnet.cad.mlcad)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
