Subject:
|
Re: Use of cursor keys in MLCad views
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Thu, 22 Mar 2001 09:07:04 GMT
|
Viewed:
|
2402 times
|
| |
| |
"Ryan Farrington" <ryanjf@ifriendly.com> wrote in message
news:00bb01c0b234$6bbd8580$73a91b3f@ifriendly.com...
> Home and End move pieces up and down in the Y axis. (I don't know if you
> knew that...)
No, I didn't - thanks for letting me know. It's still a bit of a pain as my
home and end keys are in the far top right of the keyboard and next to each
other, not vertically aligned, and my cursor keys are right at the bottom
(Ok, so it's only a six inch keyboard!), so I would still have to jump
around to move parts, and so I 've started using the arrow buttons on the
toolbar instead (I only realised what they were for last night when I
clicked them by mistake!).
Could still do with a "select" mode where you can do everything except move
a part and a "select and move" mode where you can do both.
Dan
|
|
Message is in Reply To:
3 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|