 | | Re: How do I speed things up ?
|
|
Beside the fact that the next release will be faster than 1.99R1 :-) I have another idea: What if would be possible to mark certain parts for outline or wire-frame drawing? Would that be of any help? Michael (24 years ago, 3-Nov-00, to lugnet.cad.mlcad)
|
| |
| | Re: How do I speed things up ?
|
|
(...) Yes, it would help. How about having an option to draw all prior steps in wireframe mode? Or have a meta-statement to turn wireframe off and on? Either of those might be easier to use than flagging specific parts. Steve (24 years ago, 3-Nov-00, to lugnet.cad.mlcad)
|
| |
| | Re: How do I speed things up ?
|
|
It sure would ! I was thinking along these lines a few days ago and I tried a small experiment. I manually edited copies of the .dat files for the basic bricks that my model uses and removed all of the "extraneous" quads and studs so that each part (...) (24 years ago, 3-Nov-00, to lugnet.cad.mlcad)
|
| |
| | Re: How do I speed things up ?
|
|
Michael Lachmann skrev i meddelandet ... (...) Why not a mode which paints just the bounding boxes of pieces, instead of the detailed piece? This might be easier/faster than interpreting all the .dat-s and drawing all the lines. You also see the (...) (24 years ago, 4-Nov-00, to lugnet.cad.mlcad)
|
| |
| | Re: How do I speed things up ?
|
|
I was thinking on that too, but this might be a bit confusing when parts are not like a box, like you said most of the technic parts. But sure this is also a possibility. Michael Anders Isaksson <isaksson.etuna@REMO...tninet.se> schrieb in im (...) (24 years ago, 7-Nov-00, to lugnet.cad.mlcad)
|
| |
| | Re: How do I speed things up ?
|
|
(...) In L3Lab you can see how it looks: hold down the SHIFT key while rotating the model by the mouse. /Lars (...) (24 years ago, 7-Nov-00, to lugnet.cad.mlcad)
|
