To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.mlcadOpen lugnet.cad.mlcad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / MLCad / 411
  "Step" mode for MLCad?
 
Hi, In my previous installation of MLCad, I could step through the parts of a model, and MLCad would only draw the pieces up to the part I stepped to. After a re-install, I can't find an option to enable this behaviour anymore, I always see the (...) (24 years ago, 20-Sep-00, to lugnet.cad.mlcad)
 
  Re: "Step" mode for MLCad?
 
Hakan, look under "Settings", "Change", the "Rendering" tab, in the Edit-Mode Options box, click "Draw to selected part only". I hope this is what you were looking for. Dennis (...) (24 years ago, 20-Sep-00, to lugnet.cad.mlcad)
 
  Re: "Step" mode for MLCad?
 
(...) Thanks a lot, that was exactly the option I was looking for. Regards, Hakan (24 years ago, 21-Sep-00, to lugnet.cad.mlcad)
 
  Re: "Step" mode for MLCad?
 
(...) Having this particular setting shortcutted (via a button on some toolbar, or via a cntl key sequence) would be very handy indeed. I find of the settings, this is the thing i turn on and off the most. I am OK with having to do a cntl-r to get (...) (24 years ago, 27-Sep-00, to lugnet.cad.mlcad)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR