Subject:
|
Re: MLCad Grouping Feature Specification
|
Newsgroups:
|
lugnet.cad.mlcad
|
Date:
|
Fri, 25 Feb 2000 12:42:03 GMT
|
Viewed:
|
4721 times
|
| |
|
|
SHIFT + Left klick will not work, since this is commonly used for extended
selections. e.g. Click on a part, than SHIFT click on a part 3 lines below the
first part and all parts between get selected too.
Also CTRL + left klick is used already, using ALT I havn't tried yet, but
could work.
So the problem I see is how to select just a part and not the group of parts?
Michael
In lugnet.cad.mlcad, Frank Buiting writes:
> In lugnet.cad.mlcad, Michael Lachmann writes:
> > Since many people asked for a grouping feature in MLCad, I would like to ask
> > what you think is usefull and how the grouping feature should work.
> >
> > My suggestions so far:
> >
> > - User selects one or more parts and either selects GROUP from a menu or hits
> > a short-cut or clicks onto a icon in the tool-bar.
> > QUESTION: Does it make sence to provide all three possibilities or not? If • not
> > which would you like?
>
> I prefer the toolbar the most and the shortcut as close second.
>
> > - If the user selects a part which belongs to a group the whole group will be
> > selected.
> > QUESTION: Does this make sence? Or how should it work ... I see a problem
> > getting one part removed from the group (with this solution user would have • to
> > do an ungroup, select the parts again and group again.
> > If I do not select all of them, the question is how to apply certain • operation
> > to a whole group without overloading the menus and tool-bars, and contiously
> > asking which group the user means?
>
> I would like to see it like this:
>
> Normal left click selects the group the part belongs to. If the part doesn't
> belong to a group select the part itself instead.
>
> Shift + left click selects a single piece
>
> -Frank
|
|
Message has 1 Reply:
 | | Re: MLCad Grouping Feature Specification
|
| (...) Completely different approach then... I used the Raytrace software "Imagine" on the Amiga (quite some time ago) In Imagine there was a similar thing, objects break down in groups and groups break down in faces and faces break down in points. (...) (27 years ago, 25-Feb-00, to lugnet.cad.mlcad)
|
Message is in Reply To:
| | Re: MLCad Grouping Feature Specification
|
| (...) I prefer the toolbar the most and the shortcut as close second. (...) I would like to see it like this: Normal left click selects the group the part belongs to. If the part doesn't belong to a group select the part itself instead. Shift + left (...) (27 years ago, 25-Feb-00, to lugnet.cad.mlcad)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
