|
Help!
O.K. as far as I can remember, from the work I did in LeoCAD last weekend, the
arrow keys move the selected part by 1/2 stud increments, unless the CRTL key is
held down.
However, as I'm working today, I'm noticing that the arrow keys are moving the
selected part by a full 1 stud increment. I've gone over any of the settings
I've changed in the last few days and tried to undo them, but none seem to
restore the original behavior I was seeing before.
Any thoughts on this?
Anyone?
Help!?!
Thanks!
Allan B.
|
|
Message has 1 Reply:
5 Messages in This Thread: ![You are here](/news/here.gif) ![](/news/46.gif) ![Problem solved (WAS: Keyboard input problems in LeoCAD) -Allan Bedford (8-Jun-03 to lugnet.cad.leocad)](/news/x.gif) ![](/news/46.gif) ![Re: Problem solved (WAS: Keyboard input problems in LeoCAD) -Leonardo Zide (9-Jun-03 to lugnet.cad.leocad)](/news/x.gif) ![](/news/46.gif) ![Re: Problem solved (WAS: Keyboard input problems in LeoCAD) -Kyle Henneberque (10-Jun-03 to lugnet.cad.leocad)](/news/x.gif) ![](/news/46.gif) ![Re: Problem solved (WAS: Keyboard input problems in LeoCAD) -Allan Bedford (10-Jun-03 to lugnet.cad.leocad)](/news/x.gif)
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|