To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dev.org.ldrawOpen lugnet.cad.dev.org.ldraw in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / Organizations / LDraw / 3344
  Re: STEP into using LDAO or LDDP
 
(...) You can try LDDP draw to selected line mode. This will output the model from the beginning to the selected line. -Orion (20 years ago, 11-Aug-04, to lugnet.cad.dev.org.ldraw)
 
  Re: STEP into using LDAO or LDDP
 
(...) Thanks. That's just what I'm looking for. But please pardon my ignorance. I have the basic LDDP without much plug-ins. I searched every option in the standard issue, but couldn't find the _draw to selected line mode_ option. Is that option (...) (20 years ago, 11-Aug-04, to lugnet.cad.dev.org.ldraw)
 
  Re: STEP into using LDAO or LDDP
 
(...) I had a really hard time finding that option also. And yet even so I'm not convinced it's in a bad place, since once I found it it made sense. I'm pretty sure it's in the polling menu. --Travis Cobbs (20 years ago, 11-Aug-04, to lugnet.cad.dev.org.ldraw)
 
  Re: STEP into using LDAO or LDDP
 
(...) OK, I looked it up. You want to make sure both of the following menu options are checked: Process->External Programs->Polling->Poll to L3Lab and LDView Process->External Programs->Polling->Poll to selected line only Then when you launch either (...) (20 years ago, 13-Aug-04, to lugnet.cad.dev.org.ldraw)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR