To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dev.org.ldrawOpen lugnet.cad.dev.org.ldraw in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / Organizations / LDraw / 1531
  Re: Parts Tracker - Using L3P-check to scan submitted files
 
(...) Looks good. (...) I have used the phrase "0 end of subpart", "0 end of file", etc in some of the parts I have made. Will these get rejected? I usually always try to keep them lowercase. (...) I'm not sure about this one. I feel that new parts (...) (23 years ago, 18-Oct-01, to lugnet.cad.dev.org.ldraw)
 
  Re: Parts Tracker - Using L3P-check to scan submitted files
 
(...) [snip] (...) [snip] (...) No, they should be fine. If you use a line like 0 END ROTATE (upper- or lower-case), that would cause the error message. Maybe we should have specified (back in the day, too late now) that meta-commands all have to (...) (23 years ago, 19-Oct-01, to lugnet.cad.dev.org.ldraw)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR