 | | Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
|
|
(...) Thx for pointing. I'll check that. (...) Orion and Tim are correct. Conversion should be done via LDView. As long as there is no user friendly interface with L3PAO buggy as it is today: (URL) not going to include L3P. w. (13 years ago, 27-Jun-11, to lugnet.cad.dev.org.ldraw)
|
| |
| | Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
|
|
(...) It also supports other POV parts not in LGEO. And top and bottom include files (although I think the latest L3P does that too). Tim (13 years ago, 26-Jun-11, to lugnet.cad.dev.org.ldraw, FTX)
|
| |
| | Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
|
|
(...) Well LDView exports POV code and supports LGEO. From what I've experimented with its exports seem to be better because it does mesh smoothing. -Orion (13 years ago, 26-Jun-11, to lugnet.cad.dev.org.ldraw, FTX)
|
| |
| | Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
|
|
I have a comment and a question, if I may: I started up the new AIOI, just to see what it looked like, though I killed it before it started to create anything. I noticed it now goes through a lengthy search for a previous installation. However, it (...) (13 years ago, 26-Jun-11, to lugnet.cad.dev.org.ldraw, FTX)
|
| |
| | Re: Getting Started LDraw All-In-One-Installer 2010-03 Update Now Available
|
|
(...) Not yet tested, but the description is so long. Thanks so much for your effort in completing this. cu mikeheide (13 years ago, 24-Jun-11, to lugnet.cad.dev.org.ldraw)
|
