 | | Re: Part Request: 30200
|
|
(...) Ok, I've got my calipers here, and I'm reading .1325 inches. I plug that figure into my trusty HP28S and get a conversion to 3.3655mm. I'll leave the conversion to LDUs to you :) --Karim (26 years ago, 5-Apr-99, to lugnet.cad.dev)
|
| |
| | Re: part: baseplate 33 x 32 road curve with road pattern-9 studs
|
|
i do not think it was a limit on lugnet.cad.dat. i think it may have been a limit on netscape's text control. since i use netscape for browsing the group, i cant post it. i cant get the NNTP and i do not want the Mailing list so i can't post it. if (...) (26 years ago, 5-Apr-99, to lugnet.cad.dev)
|
| |
| | Re: Complete list of metacommands?
|
|
LDS is LDraw Script, a pre-processor for .dat files that has commands like EXTRUDE and iterative loops. I'm afraid I don't have a URL, but it should not be too hard to find. The syntax of the INCLUDE directive will be defined when I release it, but (...) (26 years ago, 4-Apr-99, to lugnet.cad.dev)
|
| |
| | Re: part: baseplate 33 x 32 road curve with road pattern-9 studs
|
|
(...) Hmm, did your newsreader give you an error when you tried to post it? How big is it? 2358P01.DAT is 23518 bytes; yours must be about ~30000 bytes? That's perfectly fine to post. You could even post something as big as 3470.DAT (177792 bytes) (...) (26 years ago, 4-Apr-99, to lugnet.cad.dev)
|
| |
| | M-Peedy v1.0 released
|
|
sorry for the delay.. but i just started a new job and *all* of my time has been devoted to settling in there... M-Peedy version 1.0 is finally ready for the public... it merges any .DAT files (and all subfiles listed therein) into a single .MPD (...) (26 years ago, 4-Apr-99, to lugnet.cad.dev)
|
