To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 6684
  Re: LDRAW crash
 
(...) Definitely not without information about what you did. Error 216 is likely to be an error in LDraw, and not in a model file. Play well, Jacob (23 years ago, 2-Jan-02, to lugnet.cad.dev)
 
  Re: LDRAW crash
 
"Jacob Sparre Andersen" <sparre@nbi.dk> skrev i meddelandet news:3C33000C.485A91...@nbi.dk... (...) Both Delphi 2 and 5 (Borland Pascal) reports 216 as 'Access violation'. Probably the old Borland Pascal for DOS that James used for LDRAW uses the (...) (23 years ago, 2-Jan-02, to lugnet.cad.dev)
 
  Re: LDRAW crash
 
(...) Yep, acording to the help file, 216 is marked as "general protection error" (23 years ago, 3-Jan-02, to lugnet.cad.dev)
 
  Re: LDRAW crash  [DAT]
 
(...) Hi Jacob, I Think you are 100 percent right. First of all, it wasn't LDRAW that crashed, but it was LEDIT. Sorry abouth that :-( I guess i found the problem causing LEDIT to crach. Perhaps this is alreddy known by other people, but it seems to (...) (23 years ago, 4-Jan-02, to lugnet.cad.dev)
 
  Re: LDRAW crash
 
(...) That is a known problem with LEdit. Jacob, thanks for adding this to the FAQ. (...) I'm not sure of your exact meaning here, so I'm answering both possible meanings: Yes, if you want to *edit* your part in LEdit, you will need to break it up. (...) (23 years ago, 7-Jan-02, to lugnet.cad.dev)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR