 | | Re: Anyone modeling the Battle Droid?
|
|
Steve Bliss <blisses@worldnet.att.net> wrote in message news:li6cgsgmt3bi2um...4ax.com... (...) would (...) That looks pretty close, though on my R2 piece the shaving looks a little more severe. There's actually a small lip where the stud meets the (...) (24 years ago, 3-May-00, to lugnet.cad.dat.parts.primitives, lugnet.cad.dev)
|
| |
| | Re: LDRAW for Mac; was: Mark's Lego Creations Update!
|
|
(...) \/ Ldlite source is available and has been ported to the MAC. It could use an update though. I'm not sure if this is what you're looking for. If you need LEDIT functionality then you're out of luck. Perhaps you could use this as a starting (...) (24 years ago, 3-May-00, to lugnet.space, lugnet.starwars, lugnet.cad.dev)
|
| |
| | Re: Suggestions for new primitives: Flex-System hoses.
|
|
(...) I can do that, and post the results soon on lugned.cad.dat.parts. Note that you will not find any hoses that are exactly 120 LDU long: They normally come in somewhat "odd" lengths. As for the ribbed tube, the best way to find the length of one (...) (24 years ago, 2-May-00, to lugnet.cad.dev)
|
| |
| | Re: Suggestions for new primitives: Flex-System hoses.
|
|
(...) OK. According to Jim Hughes (via the Technica Element Registry) both the flex-system tubing and the corrugated tubing 'are widely available in many lengths'. So should we make a single "Technic Flex Tube" piece, and a single "Technic (...) (24 years ago, 2-May-00, to lugnet.cad.dev)
|
| |
| | Re: Suggestions for new primitives: Flex-System hoses.
|
|
(...) That would be great! I have worked a bit on them myself. Here's what I have done so far: (URL) used two sub parts for the ribbed hose: end and segment parts. Look for "RIBD-END.DAT" and "RIBD-SEG.DAT". These are somewhat modified from Mark R. (...) (24 years ago, 1-May-00, to lugnet.cad.dev)
|
