Subject:
|
part 2951, some questions
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Mon, 3 Jan 2000 21:34:25 GMT
|
Viewed:
|
569 times
|
| |
|
|
I've managed to measure the 2951, and now I have a few questions.
What is the preferred place for 0,0,0? I'd say exactly between the pegholes,
but this is, as you know, my first piece, so enlighten me if I'm way off.
Beneath every tooth, there is a tiny hole, there is no possible way that this
hole will ever be used for anything. How important is this hole?
As soon as I get it done, I'll put the measurements up on my homepage (I'll
get back when it is done, probably a few days) for you to review, as some of
the measurements where taken in a rather hmm creative way:)
Sincerely
John Jensen
|
|
Message has 1 Reply:
 | | Re: part 2951, some questions
|
| (...) I'd say that's a good place to put the origin. On the other hand, the user is fairly likeliy to tilt the bucket off an axle in either the upper or the lower pegholes, so centering the part in the centre of either the upper or lower pegholes (...) (25 years ago, 4-Jan-00, to lugnet.cad.dev)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
