To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 344
  Re: DAT voting page up
 
(...) Without the actual element in front of you, how can you be 100% sure that you've actually fixed the problem? (...) Have you asked yourself why you missed this in the first place? --Todd (26 years ago, 26-Feb-99, to lugnet.cad.dev)
 
  Re: DAT voting page up
 
(...) i have fixed it because i built kings mountain fortress on the part and all the studs are in place (...) it was a small oversight on my part. even if i had the part in front of me then i still could have missed the stud (26 years ago, 26-Feb-99, to lugnet.cad.dev)
 
  Re: DAT voting page up
 
Todd Lehman wrote in message ... (...) You can't. Even with a part in hand you can't because how do you know every part thru the ages is the same. A case in point, I just did an inventory of all the parts I have and found two 45 1 x 2 slopes that (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR