 | | Re: DAT voting page up
|
|
(...) i have fixed that and send the fix to terry. (...) i will fix this asap (...) i will not fix those (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
well... my raised baseplate is that accurate and is finished. (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
Sproaticus wrote in message ... (...) My vote would be to use the part number that people can see with out takeing apart the boat, i.e. the 30086 number. The 30087 number is only of value if you take the boat apart. Somthing I feel very few people (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: DAT voting page up
|
|
(...) need (...) You should measure with a ruler or with lego parts (or for detailed parts people have resorted to calipers). With a plate and a brick, you can make pretty accurate measurements based on wall thickness (4 ldu), plate thickness (8 (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
| |
| | Re: Part Numbering Crisis in LDraw
|
|
Terry K wrote in message <36d5fd53.5480877@lu...et.com>... (...) seemingly (...) number (...) both (...) I thought you had to break the two halves apart to get at the 30087 number. Do you have to break it apart? If so can you use them afterward? If (...) (26 years ago, 26-Feb-99, to lugnet.cad.dev)
|
