To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.devOpen lugnet.cad.dev in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / 3069
  Re: Comprehensive meta-command list
 
Gary Williams wrote in message ... (...) "...not dependent on any other file..." Well, I hope you agree that files depend on the inside/outside-definition of subfiles? Otherwise a file wouldn't know whether or not to use the INVERT. /Lars (25 years ago, 8-Oct-99, to lugnet.cad.dev)
 
  Re: Comprehensive meta-command list
 
(...) I think that the ideia here is: - Assume any file you reference as CCW WINDING (assuming CCW as default) - Assume any file as it's polygonal faces facing outward (if applicable) - Every time you want a diferent orientation, just use the INVERT (...) (25 years ago, 8-Oct-99, to lugnet.cad.dev)
 
  Re: Comprehensive meta-command list
 
Lars C. Hassing wrote in message <939391242.591663@ns.cci.dk>... (...) benefit. (...) I'm not sure I follow. The rendering engine will always assume an implied INVERT whenever it encounters a negative orientation matrix determinant to cancel the (...) (25 years ago, 8-Oct-99, to lugnet.cad.dev)
 
  Re: Comprehensive meta-command list
 
Gary Williams skrev i meddelelsen ... (...) vertices. (...) Right, a file should not bother whether subfiles use CCW or CW or none. But it should know the orientation (inside/outside-definition) of the subfiles. (...) I agree. /Lars (25 years ago, 9-Oct-99, to lugnet.cad.dev)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR